![]() ![]() The best way to handle this is you count the number in the group as they approach and then click the required number or times as they cross the line. Occasionally you will find a group of runners crossing the line together. Queen Elizabeth parkrun is a small event and we only average around seventy runners per week which is around half the number of runners that would cross the line per minute at the peak times at an event like Bushy parkrun so timing at QE is a fairly relaxed role. It is also good practice for the two timers to check with each other to make sure you have the same number of recorded times. The Run Director will periodically ask the timekeepers for the number of finishers which they will then check against the number of tokens handed out. This will then record the time for that finisher and it will show the number of finishers along with the time of the last finisher on the watch display. When each runner crosses the line (on their own two feet) the timer presses button B. Our two timers position themselves on opposite sides of the finish funnel. When the first finisher comes into view it is time for action. The watch then starts and you can relax for the next fifteen minutes at least. When the signal is given to start the timer presses button A once. When it is time for the event to start typically the Run Director will check with both timekeepers that they are ready and that their device is still in the correct operating mode. The secret of a successful event though is to keep things simple so I won't go into full details here. This can be used as a way of preventing accidental button clicks before the start or whilst waiting for the first finisher to arrive at the finish. The D button is also useful as you can toggle through the different operating modes. These are the ones marked A and B in the diagram above. There are only two buttons that you need to use as a timekeeper. You will also be given a full demonstration of how the device is operated. The Run Director will ensure that the batteries are ok and that the stopwatch is cleared before they hand it over to you. These are battery operated devices that take CR2032 batteries. ![]() At Queen Elizabeth parkrun we operate two JUNDS timers. At events with less than five hundred participants the most common timing device is the JUNDS stopwatch. There are a couple of different timing devices used in parkrun events. Some parkruns have a timekeeper and a backup timer but at QE we give both our timers equal responsibility. If there is a problem with one stopwatch we always have a backup. There is no reason to, it is very simple and we work with two timing devices. ![]() Timekeeper is the volunteer role that many parkrunners fear the most. parkrun uses a variety of timing devices, and it is important that the Timekeeper is familiar with the particular device in use at their event." This is one of the higher pressure jobs in the finish area, and should be reserved for those who are not easily flustered. "The Timekeeper is responsible for ensuring that the finishing time for every runner is recorded as they cross the line. The parkrun description of the timekeepers role is as follows:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |